基于相绕组电流波形的开关磁阻电机损耗研究

微特电机 ›› 2020, Vol. 48 ›› Issue (11): 25-28.

基于相绕组电流波形的开关磁阻电机损耗研究

赵勇^1,2, 曲兵妮^1,2, 宋建成^1,2, 田德翔^1,2, 宋世潮^1,2

1.太原理工大学矿用智能电器技术国家地方联合工程实验室,太原 030024;
2.太原理工大学电气与动力工程学院,太原 030024

收稿日期:2020-03-09 出版日期:2020-11-28 发布日期:2020-11-24
作者简介:赵勇(1988—),男,硕士,研究方向为电力电子与电气传动。
基金资助:
山西省重点研发计划资助项目(201803D121008)

Research on Loss of SRM Based on Phase Current Waveform

ZHAO Yong^1,2,QU Bing-ni^1,2,SONG Jian-cheng^1,2,TIAN De-xiang^1,2,SONG Shi-chao^1,2

1.National & Provincial Joint Engineering Laboratory of Mining Intelligent Electrical Apparatus Technology, Taiyuan University of Technology,Taiyuan 030024,China;
2.College of Electrical and Power Engineering, Taiyuan University of Technology, Taiyuan 030024, China

Received:2020-03-09 Online:2020-11-28 Published:2020-11-24

摘要/Abstract

摘要： 以一台三相12/8极开关磁阻电机驱动系统为研究对象,利用有限元法计算出样机的静态特性,建立了开关磁阻电机驱动系统的仿真模型,将仿真电流波形与相同工况条件下的实验平台电流波形相对比,结果表明二者吻合度好,验证了仿真模型的准确性。充分考虑了电机运行工况与控制策略对电机损耗的影响,根据仿真模型得出的电流波形,用公式法计算铜损,用时步有限元法计算铁损;分析了铁损在铁心中的分布规律。计算并分析了满载条件下,铜损和铁损随转速的变化规律,得出了总损耗随转速减小而增加的结论,为开关磁阻电机设计和控制提供依据。

关键词: 开关磁阻电机, 电流波形, 损耗, 仿真

Abstract: A three-phase 12/8-pole SRM drive system was taken as the research object. The static characteristics of the prototype were calculated by the finite element method. The simulation model of SRM drive system was established. The simulation current waveform was compared with the current waveform of the experimental platform under the same working condition. The results showed that the two were in good agreement, which verified the accuracy of the simulation model. The influence of the operation condition and control strategy of the motor on the motor loss was fully considered. According to the current waveform obtained by simulation, the copper loss was calculated by formula method; the iron loss was calculated by time stepping finite element method; and the distribution law of iron loss in iron core was analyzed. Under the condition of full load, the variation of copper loss and iron loss with rotating speed is calculated and analyzed, and the conclusion that the total loss increases with decreasing speed is obtained, which provides the basis for the design and control of SRM.

Key words: switched reluctance machine (SRM), current waveform, loss, simulation

中图分类号:

TM359.4

赵勇, 曲兵妮, 宋建成, 田德翔, 宋世潮. 基于相绕组电流波形的开关磁阻电机损耗研究[J]. 微特电机, 2020, 48(11): 25-28.

ZHAO Yong,QU Bing-ni,SONG Jian-cheng,TIAN De-xiang,SONG Shi-chao. Research on Loss of SRM Based on Phase Current Waveform[J]. Small & Special Electrical Machines, 2020, 48(11): 25-28.

参考文献 18

[1]	邱银,郝润科,赵龙,等.基于Maxwell 2D的开关磁阻电机特性仿真[J].电机与控制应用,2012,39(10):5-8,18.
[2]	刘闯,严利,严加根,等.开关磁阻电机非线性磁参数建模方法[J].南京航空航天大学学报,2007(6):706-710.
[3]	丁文,梁得亮,鱼振民,等.基于磁链与转矩特性的开关磁阻电机建模研究[J].西安交通大学学报,2007(2):214-218.
[4]	周永勤,徐爽,吴桐,等.12/8极开关磁阻电机直接转矩控制系统建模与仿真[J].哈尔滨理工大学学报,2017,22(4):75-80.
[5]	宋建国,许灵,牟蓬涛.基于Matlab 12/8极开关磁阻电机控制系统仿真[J].电力电子技术,2017,51(2):75-77,80.
[6]	李书杰,卜庆华,董健,等.开关磁阻电机调速系统建模与仿真分析[J].微电机,2010,43(10):19-21.
[7]	丁文,梁得亮.双通道开关磁阻起动/发电机系统建模与仿真[J].电机与控制学报,2011,15(5):7-15.
[8]	吴建华.开关磁阻电机的损耗针算[J].微特电机,1996(2):20-22.
[9]	SHETH N K,RAJAGOPAL K R.Estimation of core loss in a switched reluctance motor based on actual flux variations[C]//2006 International Conference on Power Electronic,Drives and Energy Systems.IEEE,2007:1-5.
[10]	YU Q,BILGIN B,EMADI A.Loss and efficiency analysis of switched reluctance machines using a new calculation method[J].IEEE Transactions on Industrial Electronics,2015,62(5):3072-3080.
[11]	RAULIN V,RADUN A,HUSAIN I.Modeling of losses in switched reluctance machines[J].IEEE Transactions on Industry Applications,2004,40(6):1560-1569.
[12]	林鹤云,周鹗,黄建中,等.开关磁阻电机磁场有限元分析与铁耗计算[J].电工技术学报,1996(1):24-29.
[13]	杨丽,刘闯,严加根.开关磁阻电机铁损的双频法有限元计算研究[J].中国电机工程学报,2006(12):117-121.
[14]	田晶,朱学忠,周翔.开关磁阻电机的铁损分析与计算[J].机电工程,2015,32(2):256-260.
[15]	董传友,李勇,丁树业,等.开关磁阻电机铁心损耗分析[J].电机与控制学报,2015,19(7):58-65.
[16]	丁文,周会军,鱼振民.开关磁阻电机磁通波形与铁耗计算[J].电机与控制应用,2006,33(6):11-17.
[17]	陆增洁,魏梦飒,陈成.基于三相全桥电路控制的开关磁阻电机铁耗计算[J].电工技术,2018(11):16-17.
[18]	李琳,宋雅吾,韩钰,等.非正弦激励下硅钢片的磁滞特性模拟及损耗计算[J].华北电力大学学报(自然科学版),2019,46(4):1-7.