微特电机 ›› 2024, Vol. 52 ›› Issue (7): 13-17.

• 设计分析 • 上一篇    下一篇

1. 5 MW 铈磁体直驱风力发电机的设计开发

李斐斐1,张世福1,何楠楠1,董生智2   

  1. 1. 北京金风科创风电设备有限公司,北京 100176; 2. 钢铁研究总院有限公司,北京 100081
  • 收稿日期:2023-08-24 出版日期:2024-07-28 发布日期:2024-09-30
  • 基金资助:
    国家重点研发专项资助项目( 2021YFB3502900)

Design and Development of 1. 5 MW Direct Drive Wind Turbine Generator with Cerium Magnet

LI Feifei1, ZHANG Shifu1, HE Nannan1, DONG Shengzhi2   

  1. 1. Goldwind Science and Creation Windpower Equipment Co. ,Ltd. ,Beijing 100176, China;
    2. Central Iron & Steel Research Institute,Beijing 100081, China
  • Received:2023-08-24 Online:2024-07-28 Published:2024-09-30

摘要: 通过铈磁体双主相技术、晶界调控技术等,开发了风电用铈磁体,并以直驱 1. 5 MW 永磁风力发电机为工程案例开展了仿真和分析,特别是磁钢厚度的适应性设计。 样机的型式试验中,对比设计值与实测值的相符度及各项性能指标的达标性,验证铈磁体在风电中应用的可行性,以及发电机总体设计方案的可行性,均能够满足机组工程化需求。 1. 5 MW 铈磁体样机的开发,为后续更高性能铈磁体在风电中的开发和应用打下了良好的基础,并提供了重要的参考依据。

关键词: 铈磁体, 直驱, 风力发电机

Abstract: Cerium magnets for wind power were developed through the dual main phase technology of cerium magnets and grain boundary control technology. Simulation and analysis were conducted using a direct drive 1. 5 MW permanent magnet wind turbine as an engineering case, especially the adaptive design of magnetic steel thickness. In the type test of the prototype, the consistency between the design values and the measured values, as well as the compliance of various performance indicators, were compared to verify the feasibility of the application of cerium magnets in wind power and the feasibility of the overall design scheme of the generator, which could meet the engineering requirements of the unit. The development of a 1. 5 MW cerium magnet prototype had laid a good foundation for the subsequent development and application of higher performance cerium magnets in wind power, and provided important reference basis.

Key words: cerium magnet, direct drive, wind turbine generator

中图分类号: